rig out
英 [ˈrɪɡ aʊt]
美 [ˈrɪɡ aʊt]
网络 打扮; 装配; 装扮
英英释义
verb
- put on special clothes to appear particularly appealing and attractive
- She never dresses up, even when she goes to the opera
- The young girls were all fancied up for the party
双语例句
- Based upon the analysis of the working conditions in the tunnel excavations, a principle design, hydraulic value design and system integration design of hydraulic drive system of cutter head for simulator test rig is carried out theoretically with electro-hydraulic proportional control technique.
论文以盾构模拟试验平台为研究对象，模拟实际盾构施工过程中的工况要求，采用电液比例控制技术对盾构模拟试验平台刀盘液压驱动系统进行了原理设计、液压阀块设计和系统集成设计。 - A test rig is set up and the experiment on the valve is carried out at the room temperature and high temperature. The experimental proportional characteristics are obtained and compared with the simulation results.
搭建了试验台，分别在常温与高温条件下进行阀的特性试验研究，给出了比例阀的比例特性曲线，并与仿真结果进行了比较。 - This rig may carry out multi-module ( CODOG and COGOG) power switch experiment under several operating modes. Measure and control system offers guarantee for the data of switching process.
此试验台可以进行多模块配置（CODOG与COGOG）及多工况下的动力切换试验，测控系统为切换过程的数据记录提供了保证。 - To use rig arm carry out single wire-line right and left percussion handle drilling tool jamming in soft sandy strata;
利用钻机大、小臂进行单绳左右冲击处理软砂地层夹钻事故； - The sergeant will rig you out with everything you need.
中士将发给你一切必需的物品。 - The sergeant will rig you out.
中士将发给你物品。 - Author point that the development emphasis of Chinese domestic on mobile rig design still on the imitation and parts selection, few investigation was carried out on the design theory and match principal.
论文指出国内的研发重点还是在模仿与部件的选型上，对于部件本身的设计原则、配套理论很少进行研究。 - It also gives out the concrete form of the compounded control system design, introduces the present actual state of the electric drive drill rig, and points out its developing directions.
给出了复合型控制系统设计的具体形式，介绍了当前电驱动钻机的现状，指出了其发展方向。 - Finite element analysis of a mast type derrick of 80 t offshore workover rig is carried out.
对80t海洋修井机井架进行了有限元计算。 - The rig tongs hinge pin, latch lock and springs must be inspected at regular intervals and changed out if excessive wear is encountered.
必须定期检查大钳的折页销子，扣合头和弹簧，如果出现磨损超标，就更换。